Vid Pin Mode for mendocinos??

BCN · Post by **BCN** » Sun Jan 05, 2003 8:51 pm

I just have one, question... does anyone have a diagram of vid pin trick for those 366's

???

and did anyone tried to get more voltage like this on these celerons? I mean more than 2.3V

I used once the program "rise of BP6" or something and managed to get them running at 2.45V... after like 45minutes of trying, cause the mobo just is not cold-booting so easily with more voltage...

hyperspace · Post by **hyperspace** » Fri Jan 10, 2003 8:50 am

Are you talking about the hard-wire modification to change the voltages? If yes, I will find the link.

BCN · Post by **BCN** » Fri Jan 10, 2003 8:39 pm

yeah, that was the hardware method.

If you know the same method for P4 Norhtwood. Drop me a link also - I will get my GB board in 2-3 weeks